Mitsubishi Electric PCA-RP71GA Manuel de service Page 68

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 80
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 67
68
OPERATING PROCEDURE PHOTOS
6. Removing the vane motor
(1) Remove the air intake grille.
(2) Remove the left side panel.
(3) Remove the relay connector of vane motor.
(4) Remove the electrical box.
(5) Remove the screws of vane motor, then remove vane
motor.
(Note)
Connect the lead wires and connectors properly and place
them in the proper position so that the wires are not pinched
by other parts.
8. Removing the Under panel
(1) Remove the air intake grille.
(2) Remove the beam.
(3) Remove the side panel (right and left).
(4) Unscrew the screws of the under panel, then remove the
under panel.
w Weight of the under panel : approx. 2kg.
7. Removing the Indoor coil thermistor
(1) Remove the air intake grille.
(2) Remove the right side panel.
(3) Remove the relay connector of the pipe thermistor.
(4) Remove the screw, and remove the check panel.
(5) Extract the indoor coil thermistor from the holder.
<Caution for the installation>
There is a possibility for the short circuit when connector gets
wet by water through the thermistor lead wire.
Therefore, lead wire of the indoor coil thermistor should be
tied as shown in the photo 5.
Photo 4
Photo 5
Photo 6
Photo 7
Screw
Screw
Screw
Hold Indoor coil thermistor Tie up
Check
panel
Relay connector of
the vane motor
Vane motor
Under panel
Relay connector of
the pipe thermistor
Left side
panel
OC311--3.qxp 04.5.31 1:05 PM Page 68
Vue de la page 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 79 80

Commentaires sur ces manuels

Pas de commentaire