Mitsubishi Electric PCA-RP71GA Manuel de service Page 67

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 80
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 66
67
Figure 3
OPERATING PROCEDURE PHOTOS&ILLUSTRATIONS
3. Removing the fan motor
(1) Remove the intake grille.
(2) Disconnect the fan motor connector.
(3) Unscrew screws for removing the motor guard.
(4) Unscrew screws for removing the fan guard.
(5) Remove the screw for removing the motor support at both
left and right side.
(6) Loosen the set screws at the fan motor side of the con-
necting joint.
(7) Slide the fan motor to the left side and pull it out.
4. Removing the sirocco fan
(1) Remove the air intake grille.
(2) Remove 1 beam.
(3) Unscrew screws for removing the motor guard.
(4) Unscrew screws for removing the fan guard.
(5) Remove the lower casing while pressing the stoppers at
upper side of the casing.
(6) Loosen the set screws at the connecting joint.
(7) Remove the sirocco fan and shaft together by sliding the
shaft to the left.
(Note)
Make sure that the upper side casing is snapped to the fan
plate securely with catch.
5. Removing the side panel
(1) Remove the air intake grille.
(2) Remove the screw from the side panel, and remove the
side panel by sliding the panel to the front.
Screw
Side panel
Sliding the panel
to the front
Photo 2
Photo 3
Screws
Motor
Set screws
Motor support
Connecting joint
Motor guard
Fan guard
Motor
Connecting joint
Sirocco fan
Casing
Bearing
Motor guard
OC311--3.qxp 04.5.31 1:05 PM Page 67
Vue de la page 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 79 80

Commentaires sur ces manuels

Pas de commentaire