Mitsubishi-electric DATA PROJECTOR Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 68
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
E-23
Power Cable Connections and Switching the Power On/Off
Finishing
1
Switch off the power of the connected equip-
ment
2
Switch off the power of the projector
Press the STANDBY button.
The [Power Off] display appears.
When the level gauge reaches maximum, the projection screen
will go off (in about 5 seconds) and the projector will enter the
power-off operation.
Note
* The operation can be cancelled by pressing a button other than
the STANDBY button.
* One more press of the STANDBY button will switch off the power.
Flashing amber
(Approximately 90
seconds)
Lit amber
Standby mode
The STANDBY indicator changes to flashing amber and lights a
steady amber after about 90 seconds (when the unit enters the
standby mode).
3
Unplug the power cable
Check that the STANDBY indicator is lit in amber and then
unplug the power cable.
The STANDBY indicator will go off when the power cable is un-
plugged.
Warrning
Do not unplug the power cable while the STANDBY indicator is flashing amber. Doing so may shorten the life of the lamp
or damage the projector.
Power Off
OK
?
STANDBY
STATUS
STANDBY
STATUS
STANDBY
STATUS
Lit green
STANDBY
(button on main unit)
LASER
AUTO
RGB
VIDEO
QUICKMENU
Q
STANDBY
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Commentaires sur ces manuels

Pas de commentaire