Mitsubishi-electric DATA PROJECTOR Manuel d'utilisateur télécharger pdf (Page 17)

E-16

Connecting Personal Computers and Video Equipment

Connecting this unit with a personal computer permits presentation data to be projected as a large screen display at

conferences, lectures, and on other occasions. Furthermore, connecting this unit to a DVD player or other video equip-

ment source in combination with an audio/video amplifier and speaker system will allow you to enjoy convincing home

theater.

Connections with Personal Computer

Please check the following before making connections with the personal computer.

• A suitable resolution for the XD70U is 1024 ⳯ 768 dots (XGA) and the maximum displayable resolution is S-XGA (1280 ⳯

1024 dots).

Make changes to a displayable resolution at the personal computer side. Please check with “Table of Supported Frequency” on

Page E-65.

• The setting method for the personal computer will differ depending on the specific model. Please read the personal computer

instruction manual or the on-line help information, or contact the manufacturer of your personal computer.

Connect the projector’s RGB connector using the included RGB signal cable.

• When making connections with the RGB connector of the projector, please make the connection via the supplied RGB signal

cable.

• The projector has been set to “Auto” at the factory; however, if it does not project, please change the input setting to “RGB”

using the menu sequence of [Setup] → [Input Format] → [RGB].

See “Input Format” on Page E-53.

• If the USB cable is connected to the projector’s MOUSE connector, mouse operations can be performed on the computer from

the projector’s remote control unit.

See “Performing Mouse Operations on the Computer with the Remote Control Unit” on Page E-32.

MONITOR OUT

Personal

computer

RGB signal cable (Supplied item)

Note:

* Before making connections, check the power of the projector and the equipment to be connected is switched off.

* When projection will be with a notebook computer connected, knowledge will be required for the cable connection and notebook computer

startup procedure as well as the operation that follows startup. Please consult the instruction manual of your notebook computer or the on-

line help.

Note:

* When the input format has been switched, you may be required to reconnect the input signal.

* If the position is off or there are dark vertical bands on the picture, press the AUTO button with the screen as bright as possible (make the

screen as bright as possible by for example displaying the trash window over the entire screen). If the problem persists after pressing the

AUTO button several times, set manually at the “Picture Adjustment” menu.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 67 68

Pas de commentaire

Mitsubishi-electric DATA PROJECTOR Manuel d'utilisateur Page 17