Mitsubishi Electric JT-SB216JSH-H-E Spécifications télécharger pdf (Page 25)

─ 25 ─

(10) Blower (assembly)

1 Remove the blower cover. → See (9) 1 to 5.

Precaution

• Since the blower (assembly) may drop off the blower case, remove

the lead wires first, and then slowly remove the blower cover.

Assembly precautions

• When replacing the blower (assembly), attach the included fixing

piece to the position, indicated by , with a screw (one PTT screw

4×16).

• Set the blower (assembly) as the lead wire outlet comes to the

position indicated by .

• The part of the lead wires covered by the white code tube must

pass through the code bush. (Indicated by )

Blower (assembly)

Set the blower horizontally.

2 Remove the blower (assembly).

Ferrite core

(11) Sensor circuit board (lower) (JT-30S3)

1 Remove the blower (assembly). → See (10) 1 to 2.

2 Unscrew the clamping screws, and remove the blower case.

(Three PTT screws 4×16, indicated by )

3 Unscrew the panel (front) and panel holder clamping screws, and

remove the panel holders (left and right).

(Five PTT screws 4×16, indicated by )

Panel (front)

Panel holder

(left)

Panel holder

(right)

3 Remove the ferrite core from the blower lead wires.

Blower case

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 58 59

Pas de commentaire

Mitsubishi Electric JT-SB216JSH-H-E Spécifications Page 25