Mitsubishi Electric PAC-YG63MCA Manuel d'instructions

Mitsubishi Electric Air Conditioner Network SystemAI controllerPAC-YG63MCAInstallation/Instruction ManualBefore using the AI controller, please read t

9(5) Configure the settings of the system controller (G(B)-50A or TG-2000A).Configure settings for the system controller (G(B)-50A or TG-2000A) such a

10Set the dip switches for function selection according to the system to be used.At the time of shipment, all dip switches are set to OFF and the M-NE

11The LEDs of this device indicate the upper/lower limit alarm interlock output status and error status of this device.10-1.Display Content List*1: Wh

12Use the following procedure to confirm operation of the system.(1) Configure the settings of this device and the system controller while referring t

WT04975X01This product is designed and intended for use in the residential,commercial and light-industrial environment.This product at hand is based o

1• Before using the device, thoroughly read the following safety precautions and use as directed.• Hazards and levels of danger that can occur due to

2• Confirm that the box contains the following parts.* In addition to the parts mentioned above, other parts need to be procured locally in order to o

36-1. Parts to be Procured LocallyPrepare the following parts to install this device.[Parts to be Purchased Separately]5 Example of System Configurati

46-2. Installation ProcedureThe AI controller PAC-YG63MCA does not have a waterproof structure.Be sure to install the AI controller inside a control p

5(3) Refer to "7. Wiring Method" and connect the wires for the power line, M-NET transmission line, and input/output signal lines.7-1. Names

67-2. Connecting the Power Line and M-NET Transmission Line7-3. Connecting the Sensors•For channel 1, select one of the following four types: Pt100 de

7(2) Channel 1 (Channel 2) Analog Input (4 to 20 mADC, 1 to 5 VDC, 0 to 10 VDC)To use these, various settings need to be configured. Refer to "8

8After completing the procedures described in "6 Installation Method" and "7 Wiring Method", set the initial settings in accordanc