Mitsubishi-electric PAC-YG60MCA Manuel d'utilisateur

Mitsubishi Electric Air Conditioner Network SystemPI controllerPAC-YG60MCAInstallation/Instruction ManualBefore using the PI controller, please read t

9After completing the procedures described in "6 Installation Method" and "7 Wiring Method", set the initial settings in accordanc

10Set the dip switches for function selection according to the system to be used. At the time of shipment, all dip switches are set to OFF and the M-N

11The LEDs of this device indicate the pulse input status and error status of this device.10-1.Display Content List*1: If a communication error occurs

12Use the following procedure to confirm operation of the system.(1) Configure the settings of this device and the system controllers while referring

WT04973X01This product is designed and intended for use in the residential,commercial and light-industrial environment.This product at hand is based o

1• Before using the device, thoroughly read the following safety precautions and use as directed.• Hazards and levels of danger that can occur due to

2• Confirm that the box contains the following parts.* In addition to the parts mentioned above, other parts need to be procured locally in order to o

35 Example of System ConfigurationNote:• For the shield ground of the M-NET centralized control line for central control, use single-point grounding a

46-1. Parts to be Procured LocallyPrepare the following parts to install this device.[Parts to be Purchased Separately][Recommended Pulse Specificatio

56-2. Installation ProcedureThe PI controller PAC-YG60MCA does not have a waterproof structure.Be sure to install the PI controller inside a control p

6(3) Refer to "7 Wiring Method" and connect the wires for the power line, M-NET transmission line, and input/output signal lines.7-1. Names

77-2. Connecting the Power Line and M-NET Transmission LineCN16 V+/V-/FG CN17 A/B/S S FG M-NETS / B / A (M1) (M2)UURTightening torque for terminal sc

87-3. Connecting the Signal Lines• Separately procure items such as terminal blocks and cables locally.• The maximum wire length is 100 m. However, si