Mitsubishi Electric HC1500 Manuel d'utilisateur télécharger pdf (Page 1)

DLP

Projector

HC1500

Controlling the projector using a personal computer

This projector can be controlled by connecting a personal computer with RS-232C terminal.

PC-controllable functions:

• Turning the power ON or OFF

• Changing input signals

• Inputting commands by pressing the buttons on the control panel and remote control

• Menu setting

Connection

To RS-232C

terminal

RS-232C cable

D-SUB 9-pin

8-pin

Important:

• Make sure that your computer and projector are turned off before connection.

• Boot up the computer ﬁ rst, and then plug the power cord of the projector.

(If you do not follow this instruction, the Com port may not function.)

• Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.

1) Interface

PROTOCOL RS-232C

BAUD RATE 9600 [bps]

DATA LENGTH 8 [bits]

PARITY BIT NONE

STOP BIT 1 [bit]

FLOW CONTROL NONE

This projector uses RXD, TXD and GND lines for RS-232C control.

For RS-232C cable, the reverse type cable should be used.

2) Control command diagram

The command consists of the address code, function code, data code, and end code. The length of the command

varies among the functions.

Address code Function code Data code End code

HEX 30h 30h Function Data 0Dh

ASCII ‘0’ ‘0’ Function Data

[Address code] 30h 30h (In ASCII code, ‘0’ ‘0’) ﬁ xed.

[Function code] A code of each ﬁ xed control move.

[Data code] A code of each ﬁ xed control data (number) and not always indicated.

[End code] 0Dh (In ASCII code, ‘ ’) ﬁ xed.

1 2 3 4 5

Résumé du contenu

Page 1 - Projector

1DLPTM ProjectorHC1500Controlling the projector using a personal computerThis projector can be controlled by connecting a personal computer with RS-23

Page 2 - 3) Control sequence

23) Control sequence(1) Send the command from the personal computer to the projector.(2) The projector will send a return command after it receives an

Page 3 - 8) Reading command diagram

36) Remote commands (Not executable in stand-by mode. When the remote commands are sent while the splash screen is being displayed, the splash screen

Page 4 - 9) Menu setting commands

49) Menu setting commands (Not executable in stand-by mode. Possible only to read during muting.)The menu setting commands are used for the menu setti

Page 5 - How to set the value

5*1) Setting range differs depending on the input signals. • Some commands are not executed depending on the input signal. The operational restrictio

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi Electric HC1500 Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Projecteurs Mitsubishi Electric HC1500. Controlling the projector using a personal Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Mitsubishi Electric HC1500 Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Projecteurs Mitsubishi Electric HC1500. Controlling the projector using a personal Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Mitsubishi Electric HC1500