Mitsubishi-electric QJ71C24N Manuel d'utilisateur télécharger pdf (Page 196)

8 - 17 8 - 17

MELSEC-Q

8 UTILITY PACKAGE (GX Configurator-SC)

[Setting Items]

The following table shows the selection menus for system setting/registration to

be displayed:

Function Section Remarks

User frame registration Section 8.4.1

Data for modem initialization registration Section 8.4.2

Data for modem connection registration Section 8.4.3

Modem function system setting Section 8.4.4

Transmission control and others system setting Section 8.4.5

MC protocol system setting Section 8.4.6

Non procedure system setting Section 8.4.7

Bidirectional system setting Section 8.4.8

PLC CPU monitoring system setting Section 8.4.9

Transmission user frame No. designation system setting Section 8.4.10

Can be used via online

operation.

Can be used via offline

operation.

Resetting buffer memory/flash ROM setting values to default values Section 8.4.11

Flash ROM write allow/prohibit setting Section 8.4.12

Can be used only via online

operation.

POINT

(1) The User's Manual (Basic) and GX Configurator-SC's Help function provide

the code list. Use this list as a reference.

(2) The values set in the respective setting screens explained in Section 8.4 can

be written to the Q series C24 module (via online operation only) or saved to a

file.

(3) Perform the following operations in advance to enable the registration of

setting values in the flash ROM:

(a) Switch setting using the GX Developer (see Section 4.5.2)

Set "Setting change" under [Transmission settings] to "Enable" for both

the CH1 and CH2 sides.

(b) Setting using GX Configurator-SC (see Section 8.4.12)

Set the flash ROM write allow/prohibit designation to "Allowed".

(4) Some system setting screens have a pair of screens: one for CH1 and the

other for CH2. Please note that the explanations given in Section 8.4.1 and

thereafter apply to the online operations performed in the CH1 screens.

The setting items are the same between CH1 and CH2, but different buffer

memory addresses are used to store the setting values. The respective

addresses are indicated as follows where applicable.

(Left side: address for the CH1 side, right side: address for the CH2 side)

Setting item

Setting value storage buffer

memory address

Reference section containing detailed

explanation

DTR/DC control

designation

/133

Chapter 7 of

User's Manual (Application)

(5) When a multiple CPU system is employed, GX Configurator-SC should be

connected to the control PLC of the Q series C24, and the system setting data

It is not possible to set target PLC to multiple CPU setting of "Transfer setup"

of GX Developer and register the system setting data in the flash ROM.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 357 358

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi-electric QJ71C24N Manuel d'utilisateur Page 196

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Mitsubishi-electric QJ71C24N