Mitsubishi-electric QJ71C24N Manuel d'utilisateur télécharger pdf (Page 171)

7 - 20 7 - 20

MELSEC-Q

7 DATA COMMUNICATIONS USING BIDIRECTIONAL PROTOCOL

1) Starts the local station PLC.

The setting values for GX Developer are stored in the Q series C24.

2) Inputs the user data transmission instruction signal.

3) Executes the BIDOUT instruction after storing the transmission data and the

control data for the BIDOUT instruction in the device.

Data is sent when the BIDOUT instruction is executed.

4) A response message for the data transmission (for normal completion: ACK

message; for abnormal completion: NAK message) is received.

5) When the response is received, the Q series C24 transmission processing

completes and the device that has completed the BIDOUT instruction turns ON.

When the BIDOUT instruction ends abnormally due to the reception of an NAK

message, the complete device +1 (abnormal completion signal) turns ON and the

error code is stored in the control data completion status (S1+1).

(Program example)

When Q series C24 I/O signals are from X/Y00 to X/Y1F:

Transmission data is stored.

Clear the transmission result storage device to 0.

Designate the transmission data count in word units.

(Designate K10 when the unit is bytes.)

The transmission data stored in the designated device is

sent.

After the BIDOUT instruction is executed, the user

designated transmission complete signal (M1) turns ON for

one scan.

Storing the transmission data and writing the transmission

data count in the buffer memory, and issuing a

transmission request to the Q series C24 are all executed

by the PLC CPU.

Designate the number of the interface (CH ) that will

send the data.

Transmission command is converted to pulse.

The completion flag is reset by the external command.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 357 358

Pas de commentaire

Mitsubishi-electric QJ71C24N Manuel d'utilisateur Page 171