Mitsubishi Electric JT-SB216JSH-H-E Manuel d'installation télécharger pdf (Page 11)

− 11 −

Test Run

Step What to check for Check

Check the power supply voltage

Is single-phase 220-240V power being used?

Incorrect power supply may cause malfunctions.

2 Turn the ground-fault circuit

interrupter on

3 Turn the power switch "ON". Is the power lamp in the display on?

4 Insert your hands to check if air is

being blown.

Is the air blowing?

Insert your hands to check if warm

air is being blown.

(Only with the J

T-

SB216JSH type

when the heater is "ON".)

(The JT-SB216KSN model does not

have a heater)

Is warm air blowing?

( If the room temperature is above 30ºC, for safety reasons

the heater will not operate even if the heater switch is

turned on.）

※ As the heater is a simple heater, if the room temperature

is less than 18ºC, the air may feel cold.

Is the heater lamp in the display on?

6 Is the appliance mounted secure

ly without any vibration or

abnormal noises?

※ Do not turn the power on while hands or other objects are inside the hand drying area.

※ If the display lamp ﬂashes, turn the power switch "OFF", check that all of the lamps on the display section are off, and

then wait for 1 minute before switching the power back "ON".

1 2 ... 6 7 8 9 10 11 12 13

Pas de commentaire

Mitsubishi Electric JT-SB216JSH-H-E Manuel d'installation Page 11